In the production process,the vibrating feeder with CE ISO Certificated And Latest Design Drive Electromotor is in the production process, and the block and granular materials can be uniformly, regularly and continuously fed into the receiving device from the storage bin. It can continuously and evenly feed the crushing machinery and coarsely screen the materials. It is widely used in crushing and screening combined equipment in metallurgy, coal mining, mineral processing, building materials, chemical industry, abrasives and other industries.

Equipment structure:

In the gravel production line, the crusher can be continuously and evenly fed to avoid clogging of the crusher receiving port. The machine with CE ISO Certificated And Latest Design Drive Electromotor uses the eccentric mass in the vibrator to generate centrifugal force, so that the movable part such as the sieve box and the vibrator acts as a forced continuous circular or approximately circular motion. The material is continuously thrown with the screen box on the inclined screen surface, and the material is continuously and uniformly sent to the receiving port.

Device installation:

1. In the vibrating feeder with CE ISOCertificated And Latest Design Drive Electromotor, it is used for batching and dosing to ensure uniform and stable feeding, and to prevent the material from self-flowing to be installed horizontally. For continuous feeding of general materials, it can be installed at 10° down. For viscous materials and materials with a large water content, they can be installed at a downward angle of 15°.
2. The feeder with CE ISOCertificated And Latest Design Drive Electromotor after installation should have a horizontal clearance of 20mm, and the suspension device should be connected flexibly.
3. Before the empty test, all the bolts should be tightened once, especially the anchor bolts of the vibration CE ISOCertificated And Latest Design Drive Electromotor. It should be tightened once for 3-5 hours.
4. When the test is started, the two vibration motors must rotate in the opposite direction, and the stability of current and noise should be stopped in time.
5. The motor bearing is filled with grease once every 2 months, and the lubricating oil should be filled once a month during the high temperature season.

   

Maintenance requirements:

1. During the operation of the feeder, the amplitude should be checked frequently, the current of the vibration motor and the surface temperature of the motor should be uniform. The front and rear amplitudes should be even, and the vibration motor should be stable. If abnormal conditions are found, stop the treatment immediately.
2. The lubrication of the vibration motor bearing is the key to the normal operation of the whole feeder. During the use, the bearing should be filled with two fluidized molybdenum 2# grease, which is filled once every two months and filled every month during the high temperature season. Once, repair the CE ISO Certificated And Latest Design Drive Electromotor once every six months and replace the internal bearing.

With Best Regards,

Cherry Zhang ( Sales Department; Miss. )   

NER GROUP CO.,LIMITED

Yantai Bonway Manufacturer Co., Ltd                                      

Tel:+86-535-6330966

Mobile:+86-18865558975

http://www.bonwaygroup.com

https://twitter.com/gearboxmotor

https://www.facebook.com/sogears1993

Viber/Line/Whatsapp/Wechat: 008618865558975   

E-mail: This email address is being protected from spambots. You need JavaScript enabled to view it.; Skepy ID:live:cherry_3053

Add:No.5 Wanshoushan Road Yantai city Shandong Province, China